Hydraulic single punch 401

A single punch immediately at work!

401Kstands for a force of kN400 with one action

Hydraulic single punch machine with 500mm throat, complete with reference table.

The machine provides active and passive safety devices, described in this manual, to protect the health and safety of personnel who operate or maintain the machine.

a Full upper casing (1), protecting the devices for punch stroke adjustment.
b Side casing (2).
c Side casing (3) for the protection of the tank.
d Control pedal (4) with protective housing. The housing is capable of retaining the operator’s shoe. This will prevent any slipping of the foot and any displacements of the pedal, thus minimizing the risk of the operator falling.
e Electrical equipment cabinet (5) can only be unlocked with the appropriate key or with mechanical means.
f Mobile detent (6) hinged to the frame of the machine. Its purpose is to protect upper limbs and hold the workpiece on the punching station. The detent can be adjusted vertically to the thickness of the workpiece but cannot be excluded without intentionally loosening the safety knob (7), which is an integral part of the machine functionality.

NOTE
The cabinet can only be opened when the equipment is off, i.e. when the main switch is in the "O" position.

ACTIVE SAFETY DEVICES

a Emergency red mushroom button (8) located on the control pedal stick (4). The foot pedal unit can be moved around so it is always within the operator’s range. The activation of the button will cause the machine to immediately stop.
b Main switch IG (9) with safety lock. When the switch is in the "I" (circuits powered up) position, the safety lock will prevent the electrical equipment cabinet from being opened.
c Single position control pedal (4). The pedal is fitted with a locking device in the idle position, which means that in order to use the pedal, the operator must have his foot completely inside the slot (to release the lock).
d Downstroke and upstroke limit switches (10), controlled by cams that can be adjusted by means of flywheels (11), and installed on a guide directly connected to the tool slide. These limit switches also act as stroke limiting devices for the optimization of the working cycles.
e Safety microswitch (12) to control the correct position of the punching station accident prevention guard (6).
f Hydraulic unit (13) operated by an electric motor (14), complete with thermal protection devices protecting against overload and overheating.
g Maximum pressure valve (15) with set, programmed opening and sealed. It protects against machine and motor overload.